Re: How to initialize power rear door
joined this forum to find out about this problem too.
here's what i found out, using a sienna guide.
i took the battery off for 5 minutes just to be safe.
reconnected it. closed all the doors and trunk.
started the sequoia, and pressed the lift gate open and close a few times.
i needed to re-initialize the trunk because i use the OEM back up camera harness inside the truck to tap into for my back up camera. i disconnected the lift gate harness and tapped power, and video feeds there.
i have installed 4 9" dvd monitors with built in dvd(so they all are master dvd). rear back up camera, front camera, pioneer avic-z1 with the z3 upgraded drive. steering wheel controls.JBL audio interface, xm nav-traffic, bluetooth. compustar pro paging alarm remote starter.
i will start a thread later on all the mods done to this truck, from head to tail :P
|