Any problems with the wiring harness from suvlights.com for the Seq's? - Toyota Tundra Forums : Tundra Solutions Forum

PagalDesi4Life · #1 (**permalink**) 08-13-2004, 05:30 AM

I was talking to Jen today from suvlights.com about the wiring harness for the seq's for the headlights and foglights (I'm thinking about getting both and putting Sylvania Silverstars in the fogs so it'd match with the headlights) and he mentioned that the resistor included with his wiring harness for the headlights might cause the lowbeams to stay on during the highbeams. I didn't get much time to talk with him as he is busy, but does anyone know about this? Anyone have any sort of problem like this with the wiring harness?

PagalDesi4Life · #2 (**permalink**) 08-18-2004, 01:29 AM

No one?

Nmerced · #3 (**permalink**) 08-18-2004, 09:14 AM

You're replacing the bulbs with Silverstars, right?

PagalDesi4Life · #4 (**permalink**) 08-18-2004, 11:32 AM

Yea, already replaced them in the headlights, still have to do them in the fog lights though.

Kzang · #5 (**permalink**) 08-18-2004, 12:33 PM

I'm kinda confused. Are you asking about the fog lights or Headlights?

When I installed... well exchanged the bulbs from stock to sylvaina silverstars I just replaced the bulbs which was pretty simple task that took me about 1 min. on each bulbs also no wiring harness was involved.

If your talking about Foglights then I don't know because I left them alone because I rather be able to see during actual foggy night.

PagalDesi4Life · #6 (**permalink**) 08-18-2004, 01:22 PM

No no no, I think everyones misunderstood, what I mean is that those that have bought the wiring harness from suvlights.com, have they had a problem with the lowbeam being on during highbeam, thats my question.

Joe · #7 (**permalink**) 08-18-2004, 01:55 PM

I don't believe you will have a problem as the low beam will only stay on if you have and use a diode-resistor plug on a harness so equipped. The Harness that the Tundra uses will be the 9003/H4 HD harness and that particular harness does not have the diode plug. The 9003/H4 harness will have 2 relays and one fuse per side - no diode-resistor plug - it will also have two connectors per side - the Toyota factory connector that plugs into the bulb (male end) will go into one of the harness's connections (female end) and the other connection (male end) will plug into the bulb.