1-ton unit bearings by spidertrax.

[spennrocks]

I was curious about these kits and if they can be applied for the tundra ifs system.

i shot an email to them, now i am turning here for more insight in the meantime.

FUB-6512

this is something i would be looking into when i get around to getting a suspension lift and other stuff.

[DevinSixtySeven]

Awesome.

You'll be building a custom spindle around it. If you could shoehorn a Hi9 under the front and run 930 CV joints on the inside, you could probably run Longfield D60 CVs and shafts to those hubs, since they're made for the 35-spline stuff.

Rear of my truck is 35-spline now. Pics somewhere in my main gallery, look for the housing partially dressed, with the shafts sticking out the end. IIRC they're about 1.5" diameter...the stock Toyota stubs are tiny in comparison.

-Sean

[spennrocks]

forgive my lack of internet-savvy, where can i check out your gallery?