Puzzled?? - Toyota Tundra Forums : Tundra Solutions Forum

Donda · #1 (**permalink**) 11-05-2009, 08:16 PM

Up until today I had three of the four door handles working ok with the LED's installed. Front and rear drivers side, and rear pass side. I tapped into the map light and went down the A pillar to the drivers front working counter clockwise ending at the pass front. What is weird is, when I added the pass front and pass puddle that are down stream from where I was when I started today, I am now getting 11.8 volts at the pass rear. The front pass and puddle are working fine. Before I started today, the front and rear driver side, and pass rear worked fine. I attached a rough sketch of what I did, the X is where I was before I started today. And yes I am adding the puddle to the drivers side, it was an after thought. Any ideas where the voltage drop is?

TheGryme · #2 (**permalink**) 11-05-2009, 08:24 PM

What's the voltage on your battery and what's the voltage b4 the first led (at the map lite)?

Donda · #3 (**permalink**) 11-05-2009, 08:43 PM

Man I would hope a little over 12, i have only had the battery a little over a month. I know that could still be the problem but it's weird that this one light now does not work and the two added lights do that are furthur down stream. Both of my led map lights and my led dome still work fine also. But the long and the short of your question, I have not checked it.