Added Note! I used my remote starter to expedite the process of removing the oil.
I put two quarts in the tube, then put the empty containers in a bucket (just in case I didn't stop it quick enough [overspill protection]) with one of the empty qt bottles--I stuck the 3 ft hose in the top and started the truck with the remote.
When each of the quart containers was filled I started the process again.
(1) Put two qts in thru dip stick
(2) Place bottles in bucket and insert tube from cooler
(3) Use remote vehicle starter to fill then remove
(4) Repeat steps 1 - 3 until all 10 qts have been poured & recovered.
|
Linear Mode
