oil pressure gauge V6

dsconstructs · #1 (**permalink**) 07-28-2003, 09:16 PM

Where is the oil pressure gauge on this 3.4L ? I had the TSB done and haven't really noticed much difference, still reads about 1/8 on the gauge when warm in gear. I would like to look at the production date and check on that. Thanks in advance
Don

Preludetundra · #2 (**permalink**) 07-29-2003, 10:04 AM

I too had the oil pressure sender guage replaced. The oil pressure guage continues to read between 0 and 1/8 when idling. Is this normal or do you think Toyota replaced one bad oil pressure sender with another?

Buzzard · #3 (**permalink**) 07-29-2003, 10:20 AM

Its was the first question I asked when I bought my 01. Mine does the same thing. ---Buzzard

dsconstructs · #4 (**permalink**) 07-29-2003, 10:30 AM

They are supposed to watch the production date on the sending unit when they replace it. It would seem strange that with the TSB and all, that it would still read so low after. That's why I'd like to check the date on the unit myself first and go from there.

Buzzard · #5 (**permalink**) 07-29-2003, 10:35 AM

Is there a TSB on this gauge?--Buzz

dsconstructs · #6 (**permalink**) 07-29-2003, 10:40 AM

See EL006-03 titled OIL PRESSURE GAUGE READS LOW in the Service Bulletins Database

TSB is applicable to 2000 – some 2003 model year Sequoia and Tundra

Moderator's Note: Post edited to remove direct link into Service Bulletins database content