Replaced my stock Tranny Cooler with B&M Supercooler

[bikol-ini]

hello, replaced my 02 seq 4wd tranny cooler with a B&M Supercooler #70264, relocate my other horn beside the other one, made extension wire with spade connection on it, the cooler mount on the same location as the stock one, just had to make a bracket to mount the cooler,

[2000LtdKen]

bikol-ini,

that thing looks cool. do you know if there are any advantages over the stock tranny cooler?

thanks,

ken

[bikol-ini]

its a much better design, being stack plates design compare to OEM, and has a much way of cooling tranny fluid, specially good if youre towing,

[mikeinaustin]

Originally Posted by bikol-ini

hello, replaced my 02 seq 4wd tranny cooler with a B&M Supercooler #70264, relocate my other horn beside the other one, made extension wire with spade connection on it, the cooler mount on the same location as the stock one, just had to make a bracket to mount the cooler,

could you give more details please ? what was the wire for? why did you have to make a bracket? did you have to buy any hoses?

[bikol-ini]

the wire was an extension so i can relocate the horn on the left side since it is on the way for the new cooler, hoses are included in the kit, plenty enough in my case, the bracket is so that i can just mount it on original location where the stock cooler was in the middle support if you look closely on the attached pix you can figure it out