DIRECTWIRE™ WIRING INFORMATION - TOYOTA / TACOMA / 2005 / Remote Start
DIRECTWIRE™ WIRING INFORMATION - TOYOTA / TACOMA / 2005 / Remote Start

[PRINT THIS PAGE]

12volts wht/blue (50A), wht/red (30A)  +  ignition harness
Starter green/black  +  ignition harness
Second Starter black/white  +  ignition harness
Ignition black/red  +  ignition harness
Second Ignition blue/yellow  +  ignition harness
Third Ignition N/A    
Accessory white/green  +  ignition harness
Second Accessory N/A    
Keysense green/black  -  ignition harness
Notes: Using the status output from the remote start to trigger this wire will disarm the factory alarm without unlocking the doors.
Power Lock purple  -  driver kick, 10 pin plug, pin 4
Notes: Meter this wire while turning the key in the driver door key cylinder.
Power Unlock green/black (double pulse)  -  driver kick, 10 pin plug, pin 8
Notes: Meter this wire while turning the key in the driver door key cylinder.

Can also use the passenger door key cylinder unlock wire, which only requires a single pulse. It is pink (-), in the passenger kick, 10 pin plug, pin 4.
Lock Motor blue/red  5wi driver kick, 12 pin plug, pin 10
Unlock Motor blue/black  5wi driver kick, 10 pin plug, pin 9
Parking Lights+ green  +  fuse box, 13 pin plug, pin 10
Parking Lights- green  -  headlight switch or BECU, pin 13
Notes: The Body ECU is attached to the back of the fuse box. It has a single 26 pin plug.
Hazards red/white or white  -  switch or turn signal flasher,pin 10
Notes: The turn signal flasher is behind the fuse box.
Turn Signal(L) red/black (F), blue/black (R)  +  turn signal flasher, pins 4 and 5
Notes: The turn signal flasher is behind the fuse box.

On models without daytime running lights, the blue/black triggers the front and rear turn signals.
Turn Signal(R) red/yellow (F), blue/yellow(R) +  turn signal flasher, pins 2 and 3
Notes: The turn signal flasher is behind the fuse box.

On models without daytime running lights, the blue/yellow triggers the front and rear turn signals.
Reverse Light red/white  +  driver kick, gray 12 pin plug, pin 1
Door Trigger green/white (ajar indicator)  -  instrument cluster or BECU, pin 4
Notes: The Body ECU is attached to the back of the fuse box. It has a single 26 pin plug.

The individual door trigger wires are at the fuse box. The LF door is green/yellow in an 18 pin plug, pin 7. The RF door is red/black in a 22 pin plug on the back, pin 8. The rear doors are pink/black in an 18 pin plug, pin 6. Use all three wires and diode isolate each.
Dome Supervision blue  -  fuse box, black 13 pin plug, pin 9
Trunk/Hatch Pin N/A    
Hood Pin N/A    
Trunk/Hatch Release N/A    
Power Sliding Door N/A    
Factory Alarm Arm arms with lock    
Factory Alarm Disarm disarms with unlock    
Disarm No Unlock use key sense wire    
Tachometer black/white  ac  data link connector, pin 9
Notes: The data link connector is under the driver side dash.

Also found at the ECM behind the glove box, second plug from the bottom, pin 1.
Wait to start N/A    
Brake Wire blue  +  fuse box, 11 pin plug, pin 2
Parking Brake green/yellow  -  fuse box, 18 pin plug, pin 5
Horn Trigger green/red  -  fuse box, 18 pin plug, pin 10
Memory Seat 1 N/A    
Memory Seat 2 N/A    
Memory Seat 3 N/A    
Immobilizer Bypass Module: Required: Yes Type: Transponder Part #: 556U or 555U
Notes: Standard on V6 models.


warning      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.