You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact contact us.
GPS and Navigation AssistanceOEM Car, Aftermarket and handheld navigation discussions.
This is a discussion thread titled "kenwood dnx7100 questions/backup cam questions", within the GPS and Navigation Assistance forum, part of the Technical & Vehicle Assistance Forums category.
I Just baught the dnx7100 with the kenwood uniiversal back up cam. My question is What do i need to do in order to run the camera when im not in reverse? I may also have some other questions later on during install. thanks in advance.
Ok well all i did was run the reverse wire from my dnx7100 and from the camera and ran int to a switch. I then fed the acc wire into the switch and concealed it under my kick panel and when i need my camera i just hit the switch no matter what gear im in or even if im parked, and it interrupts whatever and bam theres the rear view.
kenwood dnx7100 questions/backup cam questions
Linear Mode
