You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact contact us.
GPS and Navigation AssistanceOEM Car, Aftermarket and handheld navigation discussions.
This is a discussion thread titled "JBL 7006 and a BEC106", within the GPS and Navigation Assistance forum, part of the Technical & Vehicle Assistance Forums category.
Will the Eclipse BEC-106 plug and play with the JBL E7006? is there any rewiring to the plug or will it just direct fit. I read everywhere and all info is on the 105.
yes it is still plug in and play for the 4th generation e7006. just tap the pin 5 wire of the 5 pin hole sensor plug to the back up light wire found behind the dash. and plug the camera in the 4 pin canera port and it works. its prewired on 2005 aqnd 2006 trunks so on those years just plug the camera in. that is very easy compared what the 5th generation e7007 and e7009 installers have to do trying to find pins for the 24 pin camera and mic r10 connector,
Will the Eclipse BEC-106 plug and play with the JBL E7006? is there any rewiring to the plug or will it just direct fit. I read everywhere and all info is on the 105.
Thanks for any info!
I installed the BEC106 in my factory E7006 nav system last weekend. Literally plug & play and works like a charm.
I mounted the BEC106 in the tailgait handle. Then ran the wiring all the way up the passenger side frame and then into the cab just under the passenger side seat, under the carpet, around the kick panel, behind the glove box, then into the back of the head unit which was just plug and play.
JBL 7006 and a BEC106
Linear Mode
