4.7 with borla exhaust questions?? - Toyota Tundra Forums : Tundra Solutions Forum

dakine808 · #1 (**permalink**) 06-21-2009, 03:04 PM

Howzit everbody,

Just picked up a used 04 tundra, I want some exhaust and have been thinking about getting the borla, does anyone here have a 1 gen with that exhaust?

I want some rumble! not too loud, and no drone is this possible? also I was just thinking its going to be a single out system DI, single out like the stock set up any thoughts on this this?

iwantoneofthose · #2 (**permalink**) 06-22-2009, 03:41 AM

My friend has it on their '06. Don't remember how many outlets, but it was a nice low rumble, but not too obnoxious. Not sure about drone though...

Act162This · #3 (**permalink**) 06-22-2009, 05:56 PM

imho, the borlas do tend to drone a bit and resonate inside, more so at certain rpms. my friend has one on his 06, and a neighbor has one on his first gen and they both resonate quite a bit on the inside (extended cabs). on the outside, it's not much louder than stock, but for some reason, on the inside it's quite noticeable.

note - they do not have the full cat-back system, they have a universal borla in place of the stock muffler, and are running slightly larger tubing from the cat back, exiting at the stock location.

h8towork · #4 (**permalink**) 06-22-2009, 07:26 PM

I have an '04 Tundra with Borla, DI/DO, with stainless pipes and tips. It looks good and sounds great,.. until you try to listen to your stereo. But if you're upgrading to a new system, you may as well go for the Dual out look.

dakine808 · #5 (**permalink**) 06-23-2009, 12:27 PM

Right on guys for your replys! I got it installed yesterday at ESH and very HAPPY with it customer service is top notch there I highly recomend them! As for the sound, seems to be on the quiet side wich is more of my taste nowadays lol and for drone is very soft for now, I don't expect it to get anoying . Oh I just got the muffler and had them put a 3 inch tail pipe.

Act162This · #6 (**permalink**) 06-23-2009, 05:42 PM

glad to hear you are happy with it. i would have suggested ESH for the install. not the cheapest, but they've never done me wrong in over 10 years and all the cars/trucks i've had.

they stand by their work and take care of their customers - if you have any problems down the road, they will take care of them for you.

if you don't mind my asking, which shop did you go to?

dakine808 · #7 (**permalink**) 06-23-2009, 08:22 PM

I went to the one in Waipahu, yes they take care , Roland is super knowlegeable and funny.

Thanks again.