Tundra Solutions Logo

Go Back   Tundra Solutions Forum > SUV Forums > Land Cruiser

Readylift.com


Notices

Land Cruiser General discussion forum

This is a discussion thread titled "2003 Land Cruiser", within the Land Cruiser forum, part of the SUV Forums category.


Reply
 
LinkBack Thread Tools Display Modes
  #1 (permalink)  
Old 01-15-2007, 12:11 PM
Registered Member
 
My Garage
Dealer : Capitol Toyota Scion
2003 Toyota Land Cruiser
jlquach's Photo Albums
Last Online: 01-15-2007 09:50 PM
Join Date: Sep 2006
Location: Milpitas, CA
Posts: 1
Rep Power: 0
jlquach is on a distinguished road.
Default 2003 Land Cruiser

I need to know how to reset the maintenance required light on my SUV after I had done all the tune up. Please help.

Thanks
Reply With Quote

  #2 (permalink)  
Old 01-15-2007, 01:11 PM
 
My Garage
Dealer : Michael Toyota
2001 Toyota Tundra
TS Support's Photo Albums
Join Date: Oct 2005
Location: TundraSolutions.com
Posts: 789
Rep Power: 10
TS Support is on a distinguished road.
Default Re: 2003 Land Cruiser

As stated in section 1-5 of your Owner's Manual

(e) Engine Oil Replacement Reminder
Light
This light reminds you when to replace
the engine oil.
This light will come on when the ignition
switch is turned to ”ON”, and will go off
after about a few seconds.
When you drive for about 8000 km (5000
miles) after engine oil replacement, this
light flashes for about 3 seconds and then
about 12 seconds with the ignition key is
turned to ”ON” position. If you continue
driving without engine oil replacement, and
if the driving range exceeds 12000 km
(7500 miles), the light will come on after
the ignition key is turned to ”ON” position.
The light will remain on thereafter.
If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driving and
road condition. If the light comes on, replace
it as soon as possible.
You need to reset the light after the engine
oil replacement. Reset the light by
following the procedure below:
1. Turn the ignition key to the ”OFF” position
with the odometer reading shown.
(For details, see “Odometer and trip meter”
on page 117).
2. Turn the ignition key to the ”ON” position
while holding down the ”ODO/
TRIP” knob.
Hold down the knob until the light goes
off. Before the light goes off, it illuminates
for 3 seconds, flashes for 2 seconds, illuminates
for 1 second.
If the system fails to reset, the light will
remain flashing
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On
Forum Jump

Similar Threads for: 2003 Land Cruiser
Thread Thread Starter Forum Replies Last Post
2003 Tundra, Center Console Parts and Prices! atomic80 Interior & Exterior 87 08-05-2007 04:19 PM
2003 Reg cabs different? Tundra_Hick 1Gen-Tundra 5 10-02-2006 09:07 PM
How do I install fog lights in 2003 Tundra? jibbydog Electrical & Computer Systems 8 11-26-2003 06:36 AM
2003 colors r80255 Pricing and Dealers 3 05-01-2003 12:22 AM
2003 Vs Earlier Black Shocks CYCLONE 123 Suspension & Axle 7 04-29-2003 06:55 AM




All times are GMT -5. The time now is 02:31 PM.


TundraSolutions.com is a registered trademark of Tundra Solutions, Inc.
Other trademarks and brands are the property of their respective owners. Use of this Web site constitutes acceptance of the TundraSolutions.com User Agreement and Privacy Policy.
Questions? Please use the Contact Us link.  Consumer Electronics Hunter  Dealer Hunter  JPV Photography  Tundra Solutions