I need help, I just changed the timing belt on my 2003 toyota sequoia. The genious ( brother in law) who was helping me rip the wires out of cmp (cam shaft) sensor connector by mistake . Now, I have check engine / trac off / trac vsc lights on, otherwise the suv is running fine. I DONT KNOW WHICH WIRE WILL CONNECT TO WHICH PIN IN THE JACK. ONE SIDE OF THE CONNECTION HAS GREEN AND YELLOW WIRES AND THE OTHER SIDE IS RED AND WHITE. PLEASE ADVISE WHAT TO DO.
I need help, I just changed the timing belt on my 2003 toyota sequoia. The genious ( brother in law) who was helping me rip the wires out of cmp (cam shaft) sensor connector by mistake . Now, I have check engine / trac off / trac vsc lights on, otherwise the suv is running fine. I DONT KNOW WHICH WIRE WILL CONNECT TO WHICH PIN IN THE JACK. ONE SIDE OF THE CONNECTION HAS GREEN AND YELLOW WIRES AND THE OTHER SIDE IS RED AND WHITE. PLEASE ADVISE WHAT TO DO.
THANKS
Looking at the wiring diagram right now, and I don't see that colors that you are talking about. Take a picture of the connector and wires so I can see what you are talking about.
__________________
ASE Master Technician/Advanced Level Specialist
Toyota Master Diagnostic Technician
Last edited by ToyotaTech; 10-19-2009 at 11:28 AM.
wiring
. Now, I have check engine / trac off / trac vsc lights on, otherwise the suv is running fine. I DONT KNOW WHICH WIRE WILL CONNECT TO WHICH PIN IN THE JACK. ONE SIDE OF THE CONNECTION HAS GREEN AND YELLOW WIRES AND THE OTHER SIDE IS RED AND WHITE. PLEASE ADVISE WHAT TO DO.
Re: wiring
Linear Mode
