I just switched my seats (from SR5 Cloth to the Limited leather power seats). I had the power harness to te drivers side, so it was a breeze.

The passenger side on the other hand, had the airbag wiring except the power harness for the seat motor, so it doesn't move.

so I have to figure a way to get power to it. would it be easier to splice off the drivers seat power wire, or to run new wiring from somewhere else?

Anybody have a wiring schematic for the power seats?

Thanks guys.

I guess you could splice from the drivers seat power. You just might blow a fuse if you use both seat motors at the same time is all.

I guess you could splice from the drivers seat power. You just might blow a fuse if you use both seat motors at the same time is all.

does anyone have access to wiring diagrams... so I can try this.