P3 Brake controller installation

[AppliTech]

I purchased a 2007 Tundra last month and installed the P3 this weekend. It fits nicely into the ashtray slot below the center of the dashboard. There are no wiring holes to drill and the Tundra specific wiring harness supplied by Tekonsha was long enough to reach the pre-wired plug behind the driver side kick panel (just barely). I removed the ashtray mounting bracket and drill holes into it to mount the P#. I removed and cut down the ashtray plastic front piece installed it as a filler panel above the P3 to give a finished "factory installed" look. Pictures are attached. The entire installation took less than 90 minutes.

Ron

[mxsjw]

Looks good, I love the P3.

My install was similar to yours.