I have an 07 RCSB with the sport resin bumpers and since I can't get the line of fire light bar to work on my truck (clearance issues with the tailgate), I want to do a similiar led strip but smaller. I figured I could just give the led strip a ground and plug the power wire into the stock 4 pin trailer connector. But which pin do I plug into? Does anyone have a wiring diagram or know which pin does what? Any info would be appreciated.
The other two pins are for the right and left brake lights...pick one or the other...but it might blink with your turn signal. Not sure what would happen if you hooked to both at the same time..
__________________ '07 Tundra SR5, 2WD DC, 5.7L, Salsa Red Pearl with Running Boards, Delta Toolbox.
If you connect both pins your turn signals will not flash. Not a good idea!! It can be done with a full wave bridge rectifier if you're electrically inclined. Here is a link to the wiring diagram: http://www.tundrasolutions.com/forum...ler-towing.pdf
__________________
07' SR5 DC 4x4, 5.7, TRD
Toyota SS steps
ARE MX cap
AMP bed step
DIY underseat storage
Weathertech Floor Liners
Weathertech Vent Visors CBTMA member
If you connect both pins your turn signals will not flash. Not a good idea!! It can be done with a full wave bridge rectifier if you're electrically inclined. Here is a link to the wiring diagram: http://www.tundrasolutions.com/forum...ler-towing.pdf
Thanks for the wiring diagram. I guess when I get the led strip, there will just be some trial and error going on.
Tundra 4 Pin Trailer Conncetor
'07 Tundra SR5, 2WD DC, 5.7L, Salsa Red Pearl with Running Boards, Delta Toolbox.
Linear Mode
