Toyota Tundra Forums banner
abs
1-19 of 20 Results
  1. 1Gen-Brakes
    I recently replaced the front axle oil seal and rear left axle oil seal as well as new brake shoes and drums. Soon after my ABS would turn on (no ABS light) when braking at low speeds so I cleaned all 4 wheel speed sensors and found that the front right was covered in old metal filings. After...
  2. 1Gen-Sequoia
    I have a 2003 Sequoia Limited 4WD and I've been having some issues with the Slip Indicator Light, buzzer and ABS/VSC coming on while taking turns moderately fast. Anywhere from 25 mph and up going around a bend in the road, it'll usually come on. The ABS/VSC lights do not come on, but the...
  3. 2Gen-Tundra
    I have a 2014 Tundra SR5. The slip indicator and a break light (not ABS or emergency) are constantly lit. Also, the VSC On/Off switch does not seem to work. I shorted the TC and CG pins to obtain flashing error codes from the dash warning lights. Slip indicator flashed 43 and the ABS flashed...
  4. 1Gen-Brakes
    I am having trouble finding a replacement part for the ABS system (PN: 44510-0C080) in a new condition. I have a 2005 Toyota Tundra 4.7 4x4. is there a new alternate part number for this part or am I going to be stuck purchasing a used one? autozone sold me a fitting for the new brake line and...
  5. 2Gen-Brakes
    I am fairly new to this forum so I apologize if I have posted this thread incorrectly. I recently had the dealership replace the rear brakes and rotors and now when I'm cornering an on/off ramp (seems cornering anything above 20-25mph) my ABS goes nuts even when I'm not implementing the...
  6. New Member Introductions
    Appreciate anyone who can help me on this.. I have a 2011 Tundra 4x4. Last week I added wheels (18x9 Methods), and Toyo atII, 295/70/18. In one week I went from bragging about how well it drives, to scared to death to get on and off freeways. At 28-33 mph on a round on ramp, the trucks either...
  7. 1Gen-Sequoia
    Does anyone have the procedure for a 2006 4wd Sequoia SR5 on how to do clear the ZPC codes and then ZPC calibrate the master cylinder sensor, deceleration sensor, steering sensor and yaw rate sensor, etc. I see different procedures on this site, including a 2001 sequoia 2wd. I just want to...
  8. 1Gen-Sequoia
    Love this forum and soory this is a little long, but not sure how to explain it any other way. I have a 2006 Toyota Sequoia that I noticed the following and am not sure if it is normal or not: When the truck is started, brake pedal depressed and the the truck taken out of park and into N or D...
  9. Sequoia
    Hey guys was curious to know if any of the sequoias you guys own have a VSC and A trac Swith near the rear glass button on the right of the sterring wheel. I have a '12 Platinum and for whatever odd reason it doesnt come with a VSC and A-Trac switch to turn it off in 4Hi or 2wd. I know...
  10. 1Gen-Brakes
    Hey everyone, Just bought my first truck, 05 Tundra DC. Noticed it has a hydraulic power assist, not a vacuum booster. Its the whole system built into one component, ABS system, M/C, booster (electric motor w/ accumulator). In all my research I've yet to see another Tundra (or any other toyota...
  11. 1Gen-Sequoia
    my 2002 sequoia has the abs, vsc and brake lights on, i pulled three codes c1241, c1203, c1223. Can anybody tell me whats the deal? thanks arturo
  12. 2Gen-Tundra
    Hey TS's :D I need a bit of help, just a while ago I was on the beach, befor I into the sand the truck was on 2wd and auto lsd on. It was ok, after that I reversed the truck on a little hill and the tire was slipping, I stoped to engage the 4hi suddenly the 4hi was blinkinking, abs on...
  13. 1Gen-Tundra
    (Changed title) question about ABS I have a 2006 Tundra 2wd with 60k miles. Ford dealership just put in a new rear axle and they also took it to another shop to fix the blinking low tire pressure indicator. I went to pull out of the car lot and hit the brakes and it was stopping normally, but...
  14. Highlander
    Hello I need your help...i have a 2003 Highlander AWD. i live in Chicago. the weather gets pretty slick here. I noticed while driving in the snow that the ABS engages pretty quickly thus causing a loss of control in the snow. i am used to a slow gradual increase in brake performance and also...
  15. 1Gen-Tundra
    Today I came up to a busy stop and go intersection in my 05 tundra. I was doing 10 or 15 mph probably less because the Wisconsin roads are a little icy now. I slowed down way ahead of time barely on my brakes and the abs was buzzing away. The truck was just about totally stopped maybe 1mph if...
  16. 1Gen-Sequoia
    I started having trouble with the VSC TRAC lights. I was getting random grabbing on left rear. I may have a bad speed sensor there, but I wanted to share what I have learned. There are 3 pins on the OBDII connector you will use, Ts, Tc, and CG. The pins are arranged like: ......__...
  17. 1Gen-Tundra
    I have a 05 Tundra 4d 2wd (UCK31L-PRBSKA) The Brake master Cylinder is worn out but I am having problem finding the part I need online. The Master looks like it's 2 Cylinder bolted together, brake line going over the top and to the back unit and then bolted to the booster. Markin's are (AISIN...
  18. 2Gen-Tundra
    All, Sorry if this is a repeat question. Searching, I found nothing exactly like this problem. Just bought this truck about 5 days ago used. 40,000 miles on it. Beautiful truck. Loved it but now I'm a bit concerned since I just got it. About three times so far for no apparent reason the...
  19. Tacoma
    I have a 05' tacoma and I am getting ready to put new tires on. I want to go to the largest tire possible with no modifications. The store that I am working with recommends a 265/70R16. I have read that a 265/75R16 will fit with no clearance issues. the salesman says that the larger tire will...
1-19 of 20 Results
Top