Search Results for ‘brake’

Hi, I am looking at buying a 2001 Toyota Tundra, it never had the frame/brake recall performed. So it currently has no brakes due to severe rusting of frame and brake lines. Is this something that I can still have repaired under the recall? I looked over the sub to try and find a similar...

I finally managed to replace the broken factory stereo on my 2010 Sequoia Platinum with JBL everything, and it was mostly working. Steering wheel, factory amp controls, CAN bus, and the backup camera even sort of worked. Well the next drive I take the brake pedal goes to the floor as soon as the...

Brake Power Booster Seal (BENDIX) Anyone know where I can find a front seal for the brake power booster? 03' Tundra 4.7 ext cab 2wd. 300K miles Here's the part number that's on the seal. Bendix 2519607 Thanks! Conk

Does anyone know if the 1st Gen Tundras have ever been offered with a built in trailer brake? I just got a new tandem trailer with electronic brakes and I not sure if the truck has a built in system or not? Its a 2005 DC with the tow package and its shows a brake line where I plug the trailer...

I have a 2010 Tundra Double Cab and pull a 31 ft TT max load approx 8K and I am using a Teknosha P3 Brake controller. I have new brakes on the TT, all the wiring joint are soldered and insulated. From the P3 I am using the wiring harness that came with the P3 controller which has the extra...

hey folks, i search the forum I think I got the answer just want to be sure. I got 14K on my CM, anyway after the brakes get heated, I get a very hard vibration when braking, mind this happens since I got the tundra new. so is it the brake disc? :confused: thanks :D

my 2002 sequoia has the abs, vsc and brake lights on, i pulled three codes c1241, c1203, c1223. Can anybody tell me whats the deal? thanks arturo

If you're looking for a place to install your trailer brake controller without putting it in one of the boxes in the dash, I fabricated a bracket and installed it on the right side above the accelerator pedal. Stainless steel bracket and very clean.

I have a 2000 Tundra and I just installed a 2.5 Inch Daystar lift kit with strut extenders and an add a leaf and 285/75/16 tires. I have had nothing but brake issues since installing this kit I am getting a violent shaking in the rear of my truck. I have extensively researched this issue and...

(Changed title) question about ABS I have a 2006 Tundra 2wd with 60k miles. Ford dealership just put in a new rear axle and they also took it to another shop to fix the blinking low tire pressure indicator. I went to pull out of the car lot and hit the brakes and it was stopping normally, but...

I've a 2007 5.7 Tundra with 70k miles. I tow a lot, usually more than 7k to 10k pounds. Recently I hired a park-time mechanic (he has full time job, work side job on sundays) to replace my front brake (oringinal toyota pads) and he took off the rotor to Sears (they open on sunday) and...

both my 5.7 Tundra Front and Rear rotor needs to be resurface @ 70k miles now, it cost me $40 each rotor to resurface. Show I just buy NEW ones from EBAY with slotted or drilled for $350? Does the Original toyotal rotor far better than EBAY? please help, can't decide. How about brake pads...

I recently bought a 2006 Tundra SR5. My only complaint so far is a single "tick" that is clearly audible when I brake. It sounds a lot like a single tick of a blinker and happens when I break to a stop. It sounds like its coming from just behind the odometer. Surely its not a huge issue but...

Morning All, I have an 08 TRD Sport, 6pd. I bought it back in February and since it was obviously cold at the time, I noticed that when i parked it for awhile (overnight or for the hours i was at work) that when i came back to the truck, i would put my foot on the brake and it would feel...