Toyota Tundra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
Ok I got a new cat TRD exhaust system for my 06 Tacoma. I was just under there looking at the bolts with the springs on them and they look good not real rusty. So I sparyed them down with WD-40 and wire brushed them and then I was trying to turn them but I can tell these puppies are going to snap. Just want to pick up so new ones so I am ready for when they break and I need to drill them out. Can someone please tell me what size they are what by what. :ts::ts:
 

·
Registered
Joined
·
3,740 Posts
They should be 14mm head with a 10x1.25 thread. Torque is 43nm
 
1 - 2 of 2 Posts
Top