Toyota Tundra Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
333 Posts
Discussion Starter #1
I was doing a dry fit of the RideRites and see that I need to either remove the bumpstop or cut it way down.
Anyone have any advice about this?
thanks.
 

·
Premium Member
Joined
·
1,428 Posts
I cut mine off that way I wouldn't have to mess with loosening and retorquing all the u-bolts.
 

·
Registered
Joined
·
333 Posts
Discussion Starter #3
Thanks, I just did it and cutting was a much easier route than taking off then re-torquing the u bolts.
 

·
Registered
Joined
·
513 Posts
cut some, pry up with very large flat screw driver
 

·
Registered
Joined
·
333 Posts
Discussion Starter #6
CW- I thought about it, but figured what the f*&^k .
I can always get another bumpstop if needed, going on a road trip soon and didn't want to have to re-torque the bolts on the road.
 

·
Registered
Joined
·
40 Posts
When cutting off the bumper, is it possable to cut each side of the bumper with a box cutter. I believe the instructions say cut the bumper with a hack saw and cut across the base of the bumper.
 
1 - 8 of 8 Posts
Top