Toyota Tundra Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I just finished installing the ecgs bushing to eliminate the bearing growl on my new to me 2008 Tundra. After finishing the repair The CV axle and did had a very slight gap. I may be paranoid everyone I talked to said this was fine. But wanted to know if anyone had any insite. Thanks in advanced. I am assuming the gap must always be there hence why I was able to get a pry bar in between the axle and diff.
MVIMG_20200502_155147.jpg
 
1 - 1 of 1 Posts
Top