[cujo98ta]

I have been reading this forum for a while now and I was wondering if someone could explain how to remove the factory non JBL 6 disc radio? I have replaced the rear speakers and I am planning on installing the front speakers soon and at the same time I would like to run an amp to the speakers and to a sub box in the future. I am going to use the factory deck but I need to get to the wiring behind it. BTW, I have had my new Black DC 07 Tundra with the 5.7 for 3 weeks now and it's one of the best and most impressive vehicles I have owned. THANKS

 

[truckman261]

There are a couple threads on this. Basically start at the bottom piece where the 12v power outlets are and start taking out panels. There are three. You'll need an 10mm or 11mm socket for the bolts holding the deck in. There is no pre-amp out on the back of the factory deck.

 

[billcd]

Here is the thread with the radio removal info. I just hapened to be looking for the same info yesterday.

Read the PDF in the first post, it's very informative.

http://www.tundrasolutions.com/forums/tundra/97532-upgrade-to-2007-factory-nav-instructions/