Toyota Tundra Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
This morning I start my truck and it is barley idling (under 500 RPM) but it runs fine until I come to a stop then It dies.
I have a K&N intake So I read up and clean the intake (butterfly) clean the MAS still low idle.
Then I notice a hole in the vacuum line that comes off the air intake the tube is rubber then steel were it crosses the block then rubber again that is were the hole was.
Fixed it with electrical tape
Fuel line Auto part Pipe Vehicle Engine
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top