Toyota Tundra Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
This may sound like a dumb question, but what is the best way to install 1' blocks on my tundra. I understand the general process but do y'all have a certain way that you like to do it? Thanks.
 

· Registered
Joined
·
71 Posts
Discussion Starter · #5 ·
Oops, Yes, i meant 1". They are not tapered, is the any drawbacks to using the untapered blocks? So all i need to do is support the rear of the truck by the frame with jackstands while it is in the air, take my floor jack and lift the axel slightly, remove U-bolts one at a time or at the same time? and replace with longer U-bolts, slide in the blocks and re-tighten.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top