Toyota Tundra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
Hi There,


I got some measurements for FJ from Road Armor Company:


The area measured width between brackets (side to side) both inside to inside and outside to outside = inside to inside is 28” outside to outside is 38.5”.

Measures from the back side of the front face to the back face of the mounting bracket = that measurement is aprox. 7”

The face of the weld in bracket itself is 5.25” side to side.


The aprox. measurements for the bracket are as follows:


1.) front to back length = 9.25”

2.) frame span width = 3.625”

3.) top to bottom front face of bracket = 6.625”

4.) side to side width of front face = 2.5”


I hope these measurements can help you guys to say if it can be fixed or not


Thanks a lot
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top