Does anyone have any experience using OBD Fusion for getting O2 sensor data?
I have an 05 4wd DC and am getting PO420/430 CELs.
I can monitor the Downstream O2 sensor V levels but but can't get readings for the upstream O2 sensors.
The levels I'm getting for downstream are approx. .5-.8v except when I initially take my foot off of the gas.. For about 5 secs. after I take my foot of the gas it will drop to .01v but will return to .7v after about 5 seconds. I would like to compare this to the upstream O2 data but so far have been unable to..
I'm using a VeePeak OBD reader.
Any ideas?
thanks
I have an 05 4wd DC and am getting PO420/430 CELs.
I can monitor the Downstream O2 sensor V levels but but can't get readings for the upstream O2 sensors.
The levels I'm getting for downstream are approx. .5-.8v except when I initially take my foot off of the gas.. For about 5 secs. after I take my foot of the gas it will drop to .01v but will return to .7v after about 5 seconds. I would like to compare this to the upstream O2 data but so far have been unable to..
I'm using a VeePeak OBD reader.
Any ideas?
thanks