[Farnsrocket]

Did you ever fix your problem? I have the same thing going on with mine.

 

[Farnsrocket]

It's held in by two snaps/clips. Gently pry it out with a thin blade. Disconnect it then you can clean it up - it's obvious how to do that once it's removed.

Gotcha! I'm wondering if the OP's works now?

 

[Farnsrocket]

No kidding!? I have to check that out now! I just got my truck last week and tested the plug...... it has power......... and ordered a module off Ebay for $35 shipped. That will be hilarious if the "broken" one works!

 

[Farnsrocket]

This thread made me look at my controls. My '04 looks like the previous owner had a spill. Everything worked but it was pretty gummed up. I disassembled the control, popped in 3 LEDs, and cleaned the whole assembly. Looked like someone spilled a coke on the panel. Now it's all clean and not sticky.

What/how did you clean it? We're you able to take apart the panel with all the buttons? I got my used module from
eBay today and it works! Seems like my old one must have had a coke on it...... the buttons are a little sticky.

 

[Farnsrocket]

I took it apart (2 screws) and took the front panel and soaked it in warm water. Rinsed it a couple times and blew it dry with my compressor. The board had a little syrup looking stuff on it so I used warm water and a q-tip. I followed it up with isopropyl alcohol and a good dose of compressed air.

Awesome, thanks!