Toyota Tundra Forums banner
1 - 1 of 1 Posts

·
Mech. Engr. / Mechanic
Joined
·
824 Posts
REMOVAL​
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL​
Wait for 90 seconds after disconnecting the cable to prevent the
airbag working.​
2. REMOVE STEERING WHEEL PAD
NOTICE:
If the airbag connector is disconnected with the ignition
switch in the ON or ACC position, DTCs will be recorded.​
(a) Place the front wheels facing straight ahead.
(b) Remove the steering wheel lower No. 2 cover.
(c) Remove the steering wheel lower No. 3 cover.
(d) Using a torx​
® socket wrench, loosen the 2 torx® screws.
HINT:
Loosen each screw until the groove along the screw circumference
is caught on the screw case.
(e) Pull out the wheel pad from the steering wheel and disconnect
the airbag connectors and horn terminal.

CAUTION:​
​
When storing the wheel pad, keep the upper surface
of the pad facing upward.

​
Never disassemble the wheel pad.
NOTICE:
When removing the wheel pad, take care not to pull the airbag
wire harness.
3. REMOVE STEERING WHEEL

(a) Remove the steering wheel set nut.
(b) Put matchmarks on the steering wheel and main shaft assembly.
(c) Using SST, remove the wheel. (steering wheel puller)
SST 09950−50013 (09951−05010, 09952−05010,
09953−05020, 09954−05021)
(d) Disconnect the connector.​
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top