Toyota Tundra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter · #1 ·
I am getting my BFG A/T KO 305/65/18's installed in the morning along with my Readylift 3/1 leveling kit. Since I am using my factory wheels, will I need to trim or bend the skid plate at all? I am not sure I understand the whole offset stuff.

Thanks in advance!
 

·
Registered
Joined
·
1,683 Posts
Yes you will. The factory wheels are a +60 offset. The 305's are going to be almost 12" wide on the stock 8" wide wheel. Youll need to bend up the front corners of your skidplate.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top